Dusty Rose Poinsettia Crochet Pattern – Free Ornament Guide

This Dusty Rose Poinsettia Crochet Pattern creates a layered Christmas flower in soft antique pink, with dark green leaves, a cluster of gold beads, and a rustic hanging loop topped with a wooden bead. The pointed oval petals and softly raised center follow the supplied reference.

Make ten pink petals, arrange them in two staggered groups of five, and sew them onto a small backing disc. Three green leaves sit behind the flower. The petals remain separate around their outer edges so the layers keep their natural dimension.

Dusty Rose Poinsettia Crochet Pattern — cover showing layered dusty rose petals, green leaves, gold center and rustic loop

Pattern Information

  • Skill level: intermediate; working around both sides of a foundation chain and assembling several small pieces.
  • US crochet terminology.
  • Estimated flower width: 12–16 cm with sport cotton and a 2.5 mm hook; actual size depends on tension.
  • Ten dusty rose petals in two layers of five, three forest-green leaves, and one green backing disc.
  • Five gold beads form the center. A natural cord loop passes through a brown wooden bead above the flower.

This is an image-inspired adaptation. Counts and repeat structure have been reviewed, but the pattern has not been physically crocheted or independently tested. Use the written instructions for construction; photographs illustrate the intended appearance.

Materials

  • Sport cotton: approximately 25–30 g dusty rose and 5–10 g dark forest green.
  • 2–2.5 mm crochet hook matched to your yarn.
  • Tapestry needle, scissors, sewing needle, and strong matching sewing thread.
  • Five gold beads: one approximately 10 mm and four approximately 6–8 mm, with holes suitable for your thread.
  • One brown wooden bead approximately 12–15 mm with a hole large enough for two strands of cord.
  • Natural cotton or jute cord, approximately 30 cm.
  • Pins and blocking mat.

Abbreviations and Notes

  • ch: chain; sl st: slip stitch; sc: single crochet.
  • hdc: half double crochet; dc: double crochet; tr: treble crochet.
  • MR: magic ring; inc: two sc in one stitch.
  • The beginning ch 1 does not count as a stitch.
  • Work each petal around both sides of its foundation chain without turning.
  • Mark the middle of the three tip sc in Round 1: this is the tenth stitch of the round.
  • No stuffing or wire is needed. Keep sewing tails long enough to attach each piece securely.

Dusty Rose Poinsettia Crochet Pattern

1. Dusty Rose Petals — Make Ten

With dusty rose, ch 10. Keep the foundation chain firm but flexible. Start in the second chain from the hook and work into one side of the chain.

Publicity


Round 1, first side: sc in the second chain from the hook; hdc in the next chain; dc in the next; tr in each of the next two; dc in the next; hdc in the next; sc in the next. Work 3 sc in the last chain. These three sc turn around the pointed end.

Place a marker in the middle of those three tip sc. Turn the piece in your hands so the unused underside of the foundation faces you; do not turn the work over.

Round 1, second side: in the eight remaining underside chain positions, work sc, hdc, dc, tr, tr, dc, hdc, sc, one stitch per position, traveling back toward the starting end. Work 2 additional sc into the same foundation-chain position as the beginning sc. Join with a sl st to the first sc.

Round 1 total: 21 stitches: eight along the first side, three at the far tip, eight along the second side, and two extra at the base. The base chain position contains four sc altogether across the two sides and the final two extras. Joining sl st does not count.

Round 2: ch 1; sc in each of the first nine stitches. In the marked tenth stitch work (sc, ch 2, sc). Sc in each of the remaining eleven stitches. Join with a sl st to the first sc. Fasten off with a 20 cm sewing tail at the base.

Round 2 total: 22 sc and one ch-2 tip space. The extra sc at the marked tip creates the increase. Do not crochet into the joining sl st or beginning ch 1.

Make ten matching petals. The taller stitches swell the middle while the shorter stitches narrow both ends. The original chain gives a visible center line. Weave in the beginning tail on the back, leaving the long final tail for assembly.

2. Forest-Green Leaves — Make Three

Work the same two-round petal instructions in forest green, including the ch-10 foundation, 21 stitches in Round 1, and 22 sc plus a ch-2 tip in Round 2. Leave long tails for sewing.

Publicity


Keep these leaves flat. Their shape matches the pink petals, but most of each leaf will be hidden behind the flower. Only their pointed outer sections should project beyond the dusty rose layers. Do not add loose wire to hold them in place.

3. Green Backing Disc

With green, make a MR. Round 1: ch 1, 6 sc in the ring; join to the first sc [6]. Round 2: ch 1, inc in each stitch; join [12]. Round 3: ch 1, (sc, inc) six times; join [18]. Fasten off with a long tail and close the MR securely.

The disc is a sewing foundation behind the flower. It should be smaller than the finished petal spread and should not show around the front edges. Weave in its starting tail before attaching leaves.

4. Shape the Petals

Dampen the cotton pieces lightly. Pin each petal with its base rounded, sides gently curved, and ch-2 tip pointing outward. Open the tip just enough to define the point; avoid stretching it into a long hole.

Let all pieces dry completely. Keep the pink petals the same length so the flower stays balanced. They may curve slightly toward the right side; retain a gentle curve for dimension rather than forcing every piece completely flat.

5. Sew the Back Layer

Lay the backing disc on a flat surface. Position five pink petals with their bases overlapping over the disc center and their tips evenly spaced around a circle. Space them approximately one fifth of a turn apart.

Pin the bases, then use the pink tails to sew each petal to several stitches of the disc. Catch both sides of the rounded base. Add a second short seam through the neighboring petal base where they overlap. Leave the pointed ends and outer halves free.

Check from the front before tightening the seams. This first layer should make a five-point flower outline without pulling the disc into a cup.

6. Add the Front Layer and Leaves

Place the remaining five pink petals above the back layer. Rotate them so each front tip sits between two back tips, creating ten staggered points around the flower. Overlap the bases at the center.

Sew the front bases through the lower petal bases and into the disc with several small passes. Keep the stitching in the central area that will be covered by beads. Do not sew the entire petal perimeter down; the free edges create the layered appearance.

Slide the three green leaves behind the flower: two pointing diagonally upward on the left and right, and one centered between them. Adjust their angle so only the pointed outer portions show. Sew their bases to the backing disc and catch a few lower pink stitches to prevent twisting.

View the flower from both sides. Add a hidden securing pass anywhere a base moves freely. Weave all pink and green tails deeply through the backs of the stitches.

7. Gold Bead Center

Arrange one larger gold bead and four smaller gold beads in a compact cluster over the joined petal bases. Position the large bead slightly above center, with the smaller beads grouped tightly around it, following the reference.

Use doubled strong sewing thread. Sew each bead through its hole and through several dense petal-base and backing stitches, making at least three passes per bead. Secure the thread on the back between beads rather than relying on a single strand for the entire group.

Keep the beads close to the flower surface without pulling the petals inward. Knot and bury the thread ends on the back. The center should cover the assembly seams. For a bead-free version, embroider a compact gold-yarn center instead.

8. Rustic Hanging Loop and Wooden Bead

Cut approximately 30 cm of natural cotton or jute cord. Fold it in half. Thread both free ends through the wooden bead so the folded loop remains above the bead. Adjust the visible loop to about 8–10 cm high, or to your preferred hanging length.

Pass the two cord ends through separate dense areas of the upper backing disc, behind the upper petals. Tie them securely on the back, then stitch the knot and both cord tails to the disc with strong thread. Trim only after checking the attachment.

Slide the wooden bead down to sit just above the flower, with the secured cord behind the pink petals. Lift gently by the loop to check that the flower hangs upright. Spread the attachment points if it leans or rotates.

Reading the Two Complete Charts

Both chart images show the entire assembled flower: ten complete pink petal charts in staggered layers, three green leaf charts behind them, and the central backing position. The five bead positions and cord attachment are assembly guides, not crochet stitches. Dashed lines indicate sewing.

A finished-ornament photograph appears below each full chart. Use the English symbol legend with the written petal counts; the layers are separate pieces sewn together, not one continuous crochet round. The backing disc rounds are given in the text.

Finishing and Care

Gently arrange the tips and smooth the layers with your fingers. Check every bead and the hanging attachment before displaying. This is a decorative ornament with small beads and a long cord; keep it away from young children and pets.

Spot-clean the crochet gently, keeping the wood bead and jute as dry as possible. Reshape and dry flat. Store the ornament in a shallow box so the layered petals are not crushed.

Questions and Tips

Why do the petals twist? Verify that both sides use the eight-stitch sequence and that all three tip sc go into the same final chain. A foundation chain that is too tight can also distort the piece.

How many petals are there? Ten pink petals: five behind and five in front. The front layer is rotated between the back tips. Three green leaves sit behind both layers.

Why is the flower too bulky? Keep seams at the rounded bases and use only the small backing disc. Avoid folding the full petal length into the center.

Can I use red instead of pink? Yes. Dusty rose matches this reference, while red makes a traditional poinsettia. Keep all pieces in the same yarn weight.

More Free Christmas Crochet Patterns

Save This Pattern

Save this dusty rose flower for your handmade holiday collection. Happy crocheting from Lovely Amigurumi!

Tutorial, Two Complete Charts, and Pinterest Gallery

The six 1000 × 1500 images are grouped here at the end: one photo tutorial, two full chart-above-photo guides, and three Pinterest images.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top